Services
Testing, repairs and new assemblies for homes, businesses, irrigation systems and fire sprinkler lines.
Backflow testing
Yearly tests, done on time, with the paperwork sent in.
Most water districts require every backflow assembly to be tested once a year. We test it, fill in the report and send it where it needs to go, so the deadline is one less thing for you to chase.
Includes
- Yearly certification tests
- Homes, businesses, irrigation and fire sprinkler lines
- Test reports filled in and sent to your water district
- A retest after any repair
Repairs
Failed a test? We find out why and fix it.
A failed test usually comes down to worn rubber parts, debris in a check valve, or a relief valve that will not seal. We repair the assembly, test it again, and send in the passing result.
Includes
- Check valve and relief valve repairs
- Worn rubber parts and springs replaced
- Leaking and dripping assemblies
- Retest and a passing report
Installation and replacement
New assemblies, from small irrigation lines to 8-inch fire lines.
When an assembly is beyond repair, or a new one is required, we install it properly: the right type and size for the job, solidly supported, and the site left tidy. Our photos show compact brass assemblies, upright assemblies, below-ground vaults and full fire line replacements.
Includes
- Irrigation and building water lines
- Fire sprinkler lines, with monitored and locked valves
- Above ground, in vaults, in valve boxes and indoors
- Digging, new copper pipe and clean-up
Not sure which of these you need?
Email us a photo of the assembly, or of the notice from your water district, and we will tell you.